Toshiba e-STUDIO 352 - Selecting Finishing Modes; Type of Finishing Mode

99
3
3. Selecting Finishing Modes
Type of finishing mode
The available finishing modes differ depending on the type of finishing device installed (MJ-1024, MJ-
1023, MJ-1022, MJ-6004, MJ-1101 or MJ-6101). Check the available finishing modes with the table below.
Yes: Available
No: Not available
MJ-1024: Saddle Stitch Finisher
MJ-1023: Finisher (Type A)
MJ-1022: Hanging Finisher (for e-STUDIO352 only)
MJ-6004: Hole Punch Unit
MJ-1101: Finisher (Type B)
MJ-6101: Hole Punch Unit (for MJ-1101 only)
Finishing device
Type of finishing mode
Sort/
Group
Rotate
sort
Staple
sort
Maga-
zine
sort
Maga-
zine
sort &
Saddle
stitch
Saddle
stitch
Hole
punch
Man-
ual sta-
ple
MJ-1024 + MJ-6004 Yes Yes Yes Yes Yes Yes Yes No
MJ-1024 Yes Yes Yes Yes Yes Yes No No
MJ-1023 + MJ-6004 Yes Yes Yes Yes No No Yes No
MJ-1023 Yes Yes Yes Yes No No No No
MJ-1022 Yes Yes Yes Yes No No No No
MJ-1101 + MJ-6101 Yes Yes Yes Yes No No Yes Yes
MJ-1101 Yes Yes Yes Yes No No No Yes
No finishing device Yes Yes No Yes No No No No