287
9
5
Close the transport guide and the fuser unit cover. Push up the fuser
pressure release lever to return the jam releasing cover, the automatic
duplexer and the bypass tray to the original positions.
Releasing a paper misfeed in the Offset Tray Unit or Job Separator Unit
(optional)
DO NOT touch the fuser unit and the metal area around it. Since they are very hot, you could be burned or
the shock could cause an injury to your hand in the equipment.
4
Remove any misfed paper inside the
fuser unit.
1
Make sure that the bypass tray, the auto-
matic duplexer and the jam releasing
cover are open, and push down the 2
fuser pressure release levers until they
come to a stop.
Be sure to perform step 1 without fail.
2
Open the fuser unit cover.
• Remove the misfed paper from the fuser unit side if it is easier.
To Next Page
Loading...
