e-STUDIO2040C/2540C/3040C/3540C/4540C © 2011 TOSHIBA TEC CORPORATION All rights reserved
6 - 30
6. Printer-specific Adjustments (GA-1211)
Precautions after the completion of the adjustment
When use the ColorWise Pro Tools の Color Editor, if a profile to be adjusted is a CMYK Simulation Profile, be
sure to set the CMYK Simulation method. Also if a profile is a CMYK Simulation Profile, carefully check that the
correct profile is selected when more than one Output Profile is assigned to one media type. This adjustment
procedure can also be applied to the confirmation of calibration.
When Color Editor of Command WorkStation 5.x is used a detailed setting, such as simulation method cannot be
set.
To Next Page
Loading...
