1.TROUBLESHOOTING FOR THE HARDWARE
42 Clearing a Paper Misfeed
When the Hole Punch Unit is installed
6
Open the Hole Punch Unit cover.
7
Turn the green knob to get the misfed paper out.
Be sure to turn the knob to the direction indicated by the arrow to remove the misfed paper. If you pull out the
paper forcibly without turning the knob, this may tear the paper.
8
Close the Hole Punch Unit cover.
9
Close the Bridge Kit cover.
10
Close the upper receiving tray of the finisher.
Place your hands on the near and far side of the lever and push to close the tray until it clicks.
To Next Page
Loading...
