1.TROUBLESHOOTING FOR THE HARDWARE
Clearing a Paper Misfeed 45
TROUBLESHOOTING FOR THE HARDWARE
When the Hole Punch Unit is installed, open the front cover of the finisher and turn the 2 knobs at the same time.
When the Hole Punch Unit is not installed
When the Hole Punch Unit is installed
Be sure to turn the knob to the direction indicated by the arrow to remove the misfed paper. If you pull out the
paper forcibly without turning the knob, this may tear the paper.
8
Remove the misfed paper.
If the paper is caught by the roller in the exit section, remove it by lifting the roller up with your fingers.
9
Close the cover of the Bridge Unit.
To Next Page
Loading...
