2 HOW TO MAKE COPIES
38 Bypass Copying
The height of the paper must not exceed the indicator on the side guides.
When you use more than one sheet of paper, fan the sheets well before placing them on the
bypass tray. Be careful not to cut your fingers when fanning.
Do not push paper into the entrance of the bypass feeder. This could cause a paper misfeed.
If the paper is curled, turn the curled face down as indicated in the figure.
4
Select the same size button under “COPY” as that of the paper you placed on the
bypass tray.
The paper size is now set.
If the paper size is not selected in this step, copying may be slowed down.
5
Press [PAPER TYPE] on the touch panel if the paper type of the paper you placed on
the bypass tray is other than plain paper.
3
Align the side guides to the paper length while
holding the tab. Move the paper holding lever toward
the equipment.
The menu for bypass copying appears.
2
1
To Next Page
Loading...
