1 TROUBLESHOOTING FOR THE HARDWARE
44 Clearing a Paper Misfeed
Misfeed when making copies or prints (using the bypass tray)
1
Clear the paper misfeed following the guidance shown on the touch panel. Then close
all the covers.
2
Press [YES] when “Cancel print job?” appears.
The print job is canceled.
If you do not want to cancel the print job
To restart the job without canceling it, replace the paper on the bypass tray with that corresponding to
the size set in the equipment after the paper misfeed is cleared. Then if you press [NO] in step 2, the
job can be restarted. In this case, it is not necessary to follow step 3 and later.
3
Place the paper on the bypass tray and set the paper size.
4
Try copying or printing again.
Misfeed when printing from the FAX
1
Pull out the drawer in which paper misfeeds occurred
and remove all the paper from it.
If such paper misfeeds occur although [AUTO (mm)] or [AUTO
(inch)] has been selected as the paper size, this is caused by
the incorrect size detection of the paper placed in the drawer. In
this case, do not remove the paper and proceed to step 3.
2
Place the paper corresponding to the set size in the
drawer.
To Next Page
Loading...
Need help?
General
