Accessing TopAccess End-User Mode 17
Accessing TopAccess End-User Mode
To operate TopAccess, this equipment should be connected to the network and be configured
with the TCP/IP settings. After you complete the TCP/IP setup, you can access to TopAccess
web site to operate various functions from your computer using a web browser such as
Netscape Navigator and Internet Explorer.
You can use the TopAccess web-based utility from a Windows, Macintosh or Unix operating sys-
tem environment. The following browsers are supported:
Windows
y Internet Explorer 5.5 or later
y Netscape Navigator 7.1 or later
Macintosh
y Safari 2.0
y Netscape Navigator 7.1 or later
Unix
y Netscape Navigator 7.1 or later
Accessing TopAccess in end-user mode
1
To navigate to TopAccess, enter the following URL on the address
box of your Internet browser.
http://<IP Address> or http://<Device Name>
For example
When the IP address of the equipment is “10.10.70.105”:
http://10.10.70.105
When the device name of this equipment is “mfp-00c67861”:
http://mfp-00c67861
When SSL for the HTTP network service is enabled, the alert message may appear
when you enter the URL in the address box. In that case, please click [Yes] to proceed
the operation.
To Next Page
Loading...
