EasyManua.ls Logo

Toshiba e-STUDIO 520 - Page 305

Toshiba e-STUDIO 520
326 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TopAccess Error Messages 305
00E8
HDD error Retry communications. If the error still
occurs, contact your service representa-
tive.
00F0
Software failure Retry communications. If the error still
occurs, contact your service representa-
tive.
00F1
Hardware noise Retry communications. If the error still
occurs, contact your service representa-
tive.
1C10
System access abnormality Turn the power OFF and then back ON.
Perform the job in error again. If the error
still occurs, contact your service represen-
tative.
1C11
Insufficient memory When there are running jobs, perform the
job in error again after the completion of
the running jobs. If the error still occurs,
turn the power OFF and then back ON,
and perform the job again.
1C12
Message reception error Turn the power OFF and then back ON.
Perform the job in error again.
1C13
Message transmission error Turn the power OFF and then back ON.
Perform the job in error again.
1C14
Invalid parameter When a template is used, form the tem-
plate again. If the error still occurs, turn
the power OFF and then back ON, and
perform the job again.
1C15
Exceeding file capacity Ask your administrator to change the
“Fragment Page Size” setting for the Inter-
net Fax setting, or reduce the number of
pages and perform the job again.
1C20
System management module access
abnormality
Turn the power OFF and then back ON.
Perform the job in error again. If the
recovery is still not completed, contact
your service representative.
1C21-1C22
Job control module access abnormality Turn the power OFF and then back ON.
Perform the job in error again. If the
recovery is still not completed, contact
your service representative.
1C30-1C33
Disk access error When there are running jobs, perform the
job in error again after the completion of
the running jobs. If the error still occurs,
turn the power OFF and then back ON,
and perform the job again.
1C40
Image conversion abnormality Turn the power OFF and then back ON.
Perform the job in error again. If the error
still occurs, contact your service represen-
tative.
Error Code Cause Corrective Action

Table of Contents

Other manuals for Toshiba e-STUDIO 520

Related product manuals