3.Setting the IP Fax Function
24 Setting the IP Fax Function from TopAccess
8 Registrar Server Setting -
Primary
When the settings are specified for both [Primary] and [Secondary] in
[Registrar Server Setting], those for [Primary] are used.
Connection Status — Displays the last connection status.
(Blank) — A server address is not specified.
Registered — The IP address or the host name of the SIP server has been
registered.
Available — The IP address or the host name of the SIP server to be used
can be registered; however, another server has been connected.
Failed — The registration of the IP address or the host name of the SIP
server to be used has failed.
Server IP Address * — Enters the host name or the IP address of a primary
registrar. You can enter up to 128 characters. This will not be displayed if
[Auto] or [Auto(DHCPv6)] has been selected in Address Mode.
Port Number — Enters the port number for sending packets to a primary
registrar. You can enter a value in the range from 1 to 65535. Generally the
default value “5060” is used.
User Name — Enters a user name to be authenticated in a primary registrar.
You can enter up to 64 characters.
Password — Enters a password to be authenticated in a primary registrar.
You can enter up to 64 characters.
Retype Password — Enters the same password again for a confirmation.
9 Registrar Server Setting -
Secondary
When a primary registrar cannot be used, a secondary one will be utilized.
Connection Status — Displays the last connection status.
(Blank) — A server address is not specified.
Registered — The IP address or the host name of the SIP server has been
registered.
Available — The IP address or the host name of the SIP server to be used
can be registered; however, another server has been connected.
Failed — The registration of the IP address or the host name of the SIP
server to be used has failed.
Server IP Address * — Enters the host name or the IP address of a
secondary registrar. You can enter up to 128 characters. This will not be
displayed if [Auto] or [Auto(DHCPv6)] has been selected in Address Mode.
Port Number — Enters the port number for sending packets to a secondary
registrar. You can enter a value in the range from 1 to 65535. Generally the
default value “5060” is used.
User Name — Enters a user name to be authenticated in a secondary
registrar. You can enter up to 64 characters.
Password — Enters a password to be authenticated in a secondary
registrar.
You can enter up to 64 characters.
Retype Password — Enters the same password again for a confirmation.
Item name Description
To Next Page
Loading...
Need help?
General
