2INSTALLATION
22 Installing the USB Driver
9
Click [Finish] to complete the installation.
Proceed to step 10.
An additional COM port is installed on your PC by your executing USB driver installation
two times.
10
The “Add New Hardware Wizard” appears again.
Follow steps 2 to 9 to execute the USB driver installation once again.
This will install an additional COM port, e. g. COM3 if the PC already has COM1 and
COM2, through which the device driver will communicate with the e-STUDIO163/203/
165/205 device.
Proceed to step 11.
To Next Page
Loading...
