Toshiba e-STUDIO200L - Page 110

e-STUDIO200L/202L/203L/230/230L/232/233/280/282/283 © 2004 - 2010 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND SELF-DIAGNOSTIC MODE
2 - 74
472-0 Paper
feeding
Paper aligning
amount
adjustment at
the registra-
tion section
(PFP lower
drawer/Thick
paper 1)
Long size ALL 20
<0-63>
M When the value
increases by “1”, the
aligning amount
increases by approx.
0.8 mm.
<Paper length>
Long size:
330 mm or longer
Middle size:
220 mm to 329 mm
Short size:
219 mm or shorter
4
472-1 Middle
size
ALL 22
<0-63>
M4
472-2 Short size ALL 19
<0-63>
M4
473 Paper
feeding
Paper aligning amount
adjustment at the registra-
tion section
(LCF/Thick paper 1)
ALL 8
<0-63>
M1
474-0 Paper
feeding
Paper aligning
amount
adjustment at
the registra-
tion section
(Duplex feed-
ing/Thick
paper 1)
Long size ALL 24
<0-63>
M4
474-1 Middle
size
ALL 24
<0-63>
M4
474-2 Short size ALL 33
<0-63>
M4
497-0 Laser Adjustment of
drawer side-
ways devia-
tion
Upper
drawer
ALL 128
<0-255>
M When the value
increases by “1”, the
image shifts toward the
front side by 0.0423 mm.
4
497-1 Lower
drawer
ALL 128
<0-255>
M4
497-2 PFP upper
drawer
ALL 128
<0-255>
M4
497-3 PFP lower
drawer
ALL 128
<0-255>
M4
497-4 LCF ALL 128
<0-255>
M4
497-5 Bypass
feeding
ALL 128
<0-255>
M4
498-0 Laser Adjustment of
primary scan-
ning laser
writing start
position at
duplex feed-
ing
Long size ALL 148
<0-255>
M When the value
increases by “1”, the
image shifts toward the
front side by 0.0423 mm.
4
498-1 Short size
(A4/LT or
smaller)
ALL 148
<0-255>
M4
501 Image Density
adjustment
Fine adjust-
ment of “man-
ual density”/
Center value
Photo PPC 128
<0-255>
SYS When the value
increases, the image at
the center step becomes
darker.
1
503 Text/Photo PPC 128
<0-255>
SYS 1
504 Text PPC 128
<0-255>
SYS 1
505 Image Density
adjustment
Fine adjust-
ment of “man-
ual density”/
Light step
value
Text/Photo PPC 20
<0-255>
SYS When the value
increases, the image of
the “light” steps becomes
lighter.
1
506 Photo PPC 20
<0-255>
SYS 1
507 Text PPC 20
<0-255>
SYS 1
Adjustment mode (05) <e-STUDIO202L/203L/232/233/282/283>
Code
Classi-
fication
Items
Func-
tion
Default
<Accept-
able
value>
RAM Contents
Proce-
dure
007/11