Toshiba e-STUDIO200L - After Replacing the EEP-ROM (IC1002) (Electrical System (Puncher Unit; Option))

© 2004 - 2010 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO200L/202L/203L/230/230L/232/233/280/282/283
ADJUSTMENT
3 - 99
3
3.13.4 After replacing the EEP-ROM (IC1002) (Electrical system
(Puncher unit; option))
<Procedure>
(1) Turn off the host machine.
(2) Set bits 1 through 4 on the punch controller PCB as follows:
Fig. 3-132
(3) Press SW1002 and SW1003 on the punch controller PCB at the same time.
• The presses will initialize the EEP-ROM. At the end, all LEDs (LED1001, LED1002,
LED1003) will go ON.
(4) Adjust the sensor output, and store the number of punch holes.
1234
ON