Toshiba e-STUDIO200L - Page 70

e-STUDIO200L/202L/203L/230/230L/232/233/280/282/283 © 2004 - 2010 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND SELF-DIAGNOSTIC MODE
2 - 34
[5]
A LCF end fence home position sensor Fence home
position
Other than
home position
B LCF end fence stop position sensor Fence stop
position
Other than
stop position
C LCF standby side empty sensor No paper Paper present
D LCF side cover opening/closing switch Cover closed Cover opened
E LCF motor rotation status (Motor is rotating at output mode
(03))
Abnormal rota-
tion
Normal rota-
tion
F LCF tray-up sensor Tray at upper
limit position
Other than
upper limit
position
G LCF feed sensor No paper Paper present
H LCF feed side empty sensor Paper present No paper
[6]
A- --
B- --
C- --
D- --
E 1st transport sensor Paper present No paper
F- --
G Upper drawer empty sensor No paper Paper present
H Upper drawer tray-up sensor Tray at upper
limit position
Other than
upper limit
position
[7]
A- --
B- --
C- --
D- --
E 2nd transport sensor Paper present No paper
F- --
G Lower drawer empty sensor No paper Paper present
H Lower drawer tray-up sensor Tray at upper
limit position
Other than
upper limit
position
[8]
A- --
B Bypass feed paper width sensor-2 Refer to table 1
C Bypass feed paper width sensor-1 Refer to table 1
D Bypass feed paper width sensor-0 Refer to table 1
E- --
F- --
G- --
H- --
[9]
A- --
B- --
C- --
D Upper drawer detection switch Drawer not
installed
Drawer
present
E Upper drawer paper stock sensor Paper almost
empty
Paper present
F- --
G- --
H- --
Digital
key
Button Items to check
Contents
Highlighted
display
e.g.
Normal dis-
play
e.g.
05/11