e-STUDIO200L/202L/203L/230/230L/232/233/280/282/283 © 2004 - 2010 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND SELF-DIAGNOSTIC MODE
2 - 36
[FAX] button: ON ([FAX] LED: ON)
Digital
key
Button Items to check
Contents
Highlighted
display
e.g.
Normal dis-
play
e.g.
[1]
A- --
B- --
C 24 V power supply Power ON Power OFF
D IPC board connection Not connected Connected
E- --
F Polygonal motor rotation status (Motor is rotating at Output
Mode (03))
Abnormal rota-
tion
Normal rota-
tion
G Auger lock switch Lock Unlock
H Toner cartridge installation switch OFF ON
[2]
A Registration sensor Paper present No paper
B Exit sensor Paper present No paper
C Auto-toner sensor connection Not connected Connected
D Front cover opening/closing switch Cover opened Cover closed
E- --
F Side cover opening/closing sensor Cover opened Cover closed
G Transfer cover opening/closing switch Cover opened Cover closed
H Main motor rotation status (Motor is rotating at Output
Mode (03))
Abnormal rota-
tion
Normal rota-
tion
[3]
A- --
B Key copy counter connection Not connected Connected
C Job Separator upper stack sensor
(When Job Separator is installed)
Paper full Paper not full
Offset Tray separate sensor (When Offset Tray is installed) Separator at
home position
Other than
home position
D Fuser unit connection Fuser unit
installed
Fuser unit not
installed
E Bridge unit transport sensor-2 (When bridge unit is
installed)
No paper Paper present
F Bridge unit cover opening/closing detection switch
(When Bridge unit is installed)
Cover opened Cover closed
Job Separator cover switch (When Job Separator is
installed)
Cover opened Cover closed
Offset Tray cover switch (When Offset Tray is installed) Cover opened Cover closed
G Bridge unit paper full detection sensor
(When bridge unit is installed)
Paper not full Paper full
Job Separator lower stack sensor
(When Job Separator is installed)
Paper full Paper not full
Offset Tray stack sensor (When Offset Tray is installed) Paper full Paper not full
H Bridge unit transport sensor-1 (When bridge unit is
installed)
No paper Paper present
Job Separator feed sensor (When Job Separator is
installed)
Paper present No paper
Offset Tray feed sensor (When Offset Tray is installed) Paper present No paper
[4]
A- --
B- --
C- --
D- --
E- --
F Bypass feed sensor No paper Paper present
G- --
H High-voltage power supply abnormality (shutdown) detec-
tion
Normal Abnormal
05/11
To Next Page
Loading...
