e-STUDIO200L/202L/203L/230/230L/232/233/280/282/283 © 2004 - 2010 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND SELF-DIAGNOSTIC MODE
2 - 38
Table 2. Connecting status of additional options at inner area of the equipment
Table 3. Relation between the status of the original tray width sensor and paper size (width).
H (= high level): Open L (= low level): Short
[9]
A Bridge unit/Job Separator/Offset Tray connection detection-
3
Refer to table 2
B Bridge unit/Job Separator/Offset Tray connection detection-
2
Refer to table 2
C Bridge unit/Job Separator/Offset Tray connection detection-
1
Refer to table 2
D- --
E- --
F- --
G- --
H- --
[0]
A Dongle (for Printer/Scanner kit (GM-2020 or 2030)) Connectable Not connect-
able
B Dongle (for Printer kit (GM-1020 or 1030)) Connectable Not connect-
able
C Dongle (for Scanner upgrade kit (GM-3020 or 3030)) Connectable Not connect-
able
D Dongles for other equipments/Other USB devices Connectable Not connect-
able
E- --
F- --
G- --
H- --
Bridge unit Job Separator Offset Tray None
Bridge unit/Job Separator/Offset Tray
connection detection-3
Normal display Highlighting
display
Highlighting
display
Highlighting
display
Bridge unit/Job Separator/Offset Tray
connection detection-2
Highlighting
display
Highlighting
display
Normal display Highlighting
display
Bridge unit/Job Separator/Offset Tray
connection detection-1
Normal display Normal display Normal display Highlighting
display
Original tray width sensor
Paper width size
(LT series)
Paper width size
(A4 series)
TWID2S TWID1S TWID0S
H
HH
LD/LT A3/A4
HHL -
B5-R
HLH
ST-R A5-R
L
HH LD/LT
A3/A4
LHL -
-
LLH
8.5" x 8.5" / LT-R / LG /
13" LG
A4-R/FOLIO
L L L COMPUTER B4/B5
Digital
key
Button Items to check
Contents
Highlighted
display
e.g.
Normal dis-
play
e.g.
08/04
To Next Page
Loading...
