Toshiba e-STUDIO230 - Paper Alignment at the Registration Roller

© 2004 - 2010 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO200L/202L/203L/230/230L/232/233/280/282/283
ADJUSTMENT
3 - 5
3
3.2.2 Paper alignment at the registration roller
The aligning amount is adjusted by using the following codes in Adjustment Mode (05).
Sub-code
(*1) 0: Long size 1: Middle size 2: Short size
(*2) 0: Long size 1: Middle size 2: Short size 3: Post card
(*3) 0: Long size of OHP film 1: Middle size of OHP film 2: Short size of OHP film
Notes:
1. Long size: 330 mm or longer (13.0 inches or longer)
Middle size: 220-239 mm (8.7-12.9 inches)
Short size: 219 mm or shorter (8.6 inches or shorter)
2. The adjustment of “Post card” is for Japan only.
<Procedure>
(1) Perform the test print according to the following procedure.
Paper
type
Weight
Upper
drawer
Lower
drawer
PFP upper
drawer
PFP lower
drawer
LCF ADU
Bypass
feed
Plain
paper
64-80 g/m
2
17-20 lb.
450 (*1) 452 (*1) 448 (*1) 449 (*1) 457 455 (*1) 458 (*1)
Thick
paper 1
81-105g/m
2
21-28 lb.
469 (*1) 470 (*1) 471 (*1) 472 (*1) 473 474 (*1) 460 (*1)
Thick
paper 2
106-163g/m
2
29-43 lb.
- - - - - - 461 (*1)
Thick
paper 3
164-209g/m
2
44-55 lb.
- - - - - - 462 (*2)
OHP - - - - - - - 463 (*3)
(*4) 1: Single-sided grid pattern 3: Double-sided grid pattern
(Code) [START] (Sub-code) [START]
[0][5]
[Power]
Current value
displayed
Enter new
value
[POWER]
OFF/ON
(Exit)
[Drawer
selection]
(*4) +[FAX]
(Test print)
[SET] or
[INTERRUPT]
Stores in memory
(Not necessary for LCF)