© 2004 - 2010 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO200L/202L/203L/230/230L/232/233/280/282/283
ADJUSTMENT
3 - 87
3
3.12.2 Adjusting the angle of the jogging plate
<Procedure>
(1) Without removing the processing tray unit,
loosen the 2 mounting screws of the rear jog-
ging plate.
Fig. 3-114
(2) Place several sheets of A4/LT paper on the
processing tray, and adjust the rear jogging
plate. (At this time, adjust the gap between
the paper and the front end of the rear jog-
ging plate so that it is 0 mm to 0.5 mm.)
Fig. 3-115
(3) With reference to the rear jogging plate
adjusted in step (2), adjust the front jogging
plate in the same manner.
To Next Page
Loading...
