Toshiba e-STUDIO230 - Adjustment of the Scanner Section

e-STUDIO200L/202L/203L/230/230L/232/233/280/282/283 © 2004 - 2010 TOSHIBA TEC CORPORATION All rights reserved
ADJUSTMENT
3 - 42
3.7 Adjustment of the Scanner Section
3.7.1 Carriages
[A] Installing carriage wires
When replacing the carriage wires, refer illustrations below:
[Front side]
Fig. 3-29
[Rear side]
Fig. 3-30
Adjustment of the carriage wire tension is not necessary since a certain tension is applied to the car-
riage wires by the tension springs.
Note: Note:
Make sure the tension applied to the wire is normal.
Carriage-2
Idler pulley
Tension spring
Wire pulley
Bracket for carriage-1
Hook
Carriage wire
Carriage-2
Carriage wire
Bracket for carriage-1
Hook
Wire pulley
Tension spring
Idler pulley