© 2004 - 2010 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO200L/202L/203L/230/230L/232/233/280/282/283
TROUBLESHOOTING
5 - 45
5
[ 4 ] Paper jam in saddle stitcher section
[EAB0] Saddle paper transport stop jam
MJ-1025
Is there any paper remaining on the paper transport path in the saddle stitcher section in the
finisher?
YES Remove the paper.
NO
Is the connector CN16 (folding position sensor) on the finisher controller PC board discon-
nected?
Is the harness connecting the finisher controller PC board and folding position sensor open-
circuited?
YES Connect the connector securely. Replace the harness.
NO
Is the folding position sensor working properly?
NO Replace the sensor.
YES
Replace the finisher controller PC board.
[EAC0] Saddle transport delay jam
MJ-1025
Is there any paper remaining on the paper transport path in the saddle stitcher section in the
finisher?
YES Remove the paper.
NO
Is the connector CN16 (folding position sensor) on the finisher controller PC board discon-
nected?
Is the harness connecting the finisher controller PC board and folding position sensor open-
circuited?
YES Connect the connector securely. Replace the harness.
NO
Is the folding position sensor working properly?
NO Replace the sensor.
YES
Replace the finisher controller PC board.
To Next Page
Loading...
