e-STUDIO200L/202L/203L/230/230L/232/233/280/282/283 © 2004 - 2010 TOSHIBA TEC CORPORATION All rights reserved
TROUBLESHOOTING
5 - 64
[Procedure 3]
Does the tray go up?
l
l
l
l
l
l
l
l
l
l
l
l
YES
NO Is 24 VDC supplied from the finisher controller PCB to the shift motor as
soon as the tray is driven?
NO Replace the finisher controller PC board.
YES
Is there any problem with the tray up/down mechanism?
YES Fix the lift mechanism.
NO
Replace the shift motor.
Is the shift motor clock sensor (PI7) working properly?
YES Replace the finisher controller PC boar
NO
Replace the sensor.
[CB50] Staple motor abnormality
MJ-1025
[Procedure 1]
Is the wiring between the finisher controller PC board and the staple/fold motor normal?
NO Correct the wiring.
YES
Try to rotate the staple jam releasing dial. Is there mechanical trapping?
YES Fix the mechanism.
NO
Try replacing the staple/fold motor (M7). Is the problem corrected?
YES End.
NO
Replace the finisher controller PC board.
To Next Page
Loading...
