© 2004 - 2010 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO200L/202L/203L/230/230L/232/233/280/282/283
FIRMWARE UPDATING
6 - 35
6
(4) Connect the download jig with the jig connector (CN100) on the SYS board.
Fig. 6-37
(5) Turn ON the power while [8] button and [9] button are pressed simultaneously.
The screen for selecting the items to be updated is displayed. “*” is displayed next to the items to
be updated. (All items are selected in the default settings.)
When the FROM basic section software version to be updated is "V1.00 / 1.12" or earlier:
Fig. 6-38
When the FROM basic section software version to be updated is "V1.00 / 4.22" or later:
Fig. 6-39
Connector
06/10
To Next Page
Loading...
