Toshiba e-STUDIO230 - Page 81

© 2004 - 2010 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO200L/202L/203L/230/230L/232/233/280/282/283
ERROR CODE AND SELF-DIAGNOSTIC MODE
2 - 45
2
Procedure 6
* When the automatic adjustment ends abnormally, error message is displayed.
Procedure 7
* When the automatic adjustment ends abnormally, error message is displayed.
Procedure 10
Procedure 17
* When the “storing is not performed within 2 minutes after pressing the [START] button at the
manual adjustment, the “automatic adjustment” starts automatically.
Note: Note:
The fuser roller temperature control at the adjustment mode is different from that at the normal
state.
Therefore, the problem of fusing efficiency may be occurred in the test copy at the adjustment
mode. In that case, turn ON the power normally, leave the equipment for approx. 3 minutes after
it has become ready state and then start up the adjustment mode again.
[0][5]
[POWER]
[POWER]OFF/ON
(Exit)
[Digital key]
(Code)
[START]
()
Automatic
adjustment
([FAX])
(Test copy)
*[CANCEL] or [CLEAR]
[0][5]
[POWER]
[POWER]
OFF/ON
(Exit)
[Digital key]
(Code)
[START]
()
Automatic
adjustment
([FAX])
(Test copy)
*[CANCEL] or [CLEAR]
[CANCEL]
()
[ENTER]
Stores value
in RAM
[0][5]
[POWER]
[POWER]
OFF/ON
(Exit)
[Digital key]
(Code)
[Digital key]
(Sub code)
[START] [START][START]
[SET] or [INTERRUPT]
(Value unchangeable)
()
Value
displayed
[0][5]
[POWER]
[POWER]
OFF/ON
(Exit)
[Digital key]
(Code)
[START]
Automatic
adjustment
[ENTER]
or
[INTERRUPT]
Stores value
in RAM
()
[ENTER]
or
[INTERRUPT]
Stores value
in RAM
()
([FAX])
(Test copy)
[UP]
or
[DOWN]
(Adjust a value)
[CANCEL] or [CLEAR]
()
[UP]
or
[DOWN]
(Adjust a value)
[CANCEL] or [CLEAR]
)
(
Manual
adjustment