Toshiba e-studio2307 - Test Print Pattern in Adjustment Mode (05)

e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A © 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
SELF-DIAGNOSIS MODES
5 - 10
5.6 Test print pattern in Adjustment Mode (05)
The test print pattern is printed by inputting the following code in adjustment mode (05) and then
pressing the [SETTINGS] button and then the [START] button.
Remarks:
Select DRAWER (DRAWER1/BYPASS) and then you can print.
<Procedure>
1. [0]+[5]+[POWER].
2. Input the code.
3. Press [SETTINGS].
4. Use the [Arrow] buttons to select “Paper Source” and then press [START].
Code Types of test pattern Remarks
1 Grid pattern Refer to  P. 6-8 "6.3.4 Printer related
adjustment".
3 Grid pattern (Duplex printing) Refer to  P. 6-8 "6.3.4 Printer related
adjustment".
6 Copier gamma confirmation pattern For confirming the reproduction of gradation.
10 Copier gamma adjustment pattern Refer to  P. 6-23 "6.4.1 Automatic gamma
adjustment".
20 Copier gamma adjustment pattern (Black; binary
dithering)
For confirming the reproduction of gradation.
(05-7167)
Refer to  P. 6-23 "6.4.1 Automatic gamma
adjustment".