Toshiba e-studio2307 - Skew (Inclined Image)

e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A © 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
8 - 78
8.4.11 Skew (inclined image)
Fig.8-13
Defective area Step Check items Prescription
Drawers 1 Is the drawer properly installed? Install the drawer properly.
2 Is there too much paper in the
drawer?
Reduce paper to 250 or fewer sheets
in the drawer.
3 Is the corner of the paper folded? Change the direction of the paper
and set it again.
4 Are the side guides of the drawer
properly installed?
Adjust the position of the side guides.
Feed roller 5 Is the surface of the feed roller dirty? Clean the feed roller surface with
alcohol, or replace the roller.
Rollers 6 Are the roller and shaft secured? Check and tighten the E-rings, pins,
clips and setscrews.
Registration roller 7 Is the spring detached from the
registration roller?
Attach the spring correctly. Clean the
roller if it is dirty.
Pre-registration guide 8 Is the pre-registration guide properly
installed?
Correct it.
CIS unit 9 Is the CIS unit slanted? Replace the CIS case.
Feeding direction