Toshiba e-studio2307 - Paper Alignment at the Registration Roller

e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A © 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
SETTING / ADJUSTMENT
6 - 6
6.3.3 Paper alignment at the registration roller
The aligning amount is adjusted by using the following codes in Adjustment Mode (05).
Sub-code
(*1) 0: Long size 1: Middle size 2: Short size
(*2) 0: Long size 1: Middle size 2: Short size 3: Post card
(*3) 0: Long size of OHP film 1: Middle size of OHP film 2: Short size of OHP film
(*4) 0: Long size of Envelope 1: Middle size of Envelope 2: Short size of Envelope
Notes:
1. Long size: 330 mm or longer (13.0 inches or longer)
Middle size: 220-239 mm (8.7-12.9 inches)
Short size: 219 mm or shorter (8.6 inches or shorter)
<Procedure>
(1) Perform the test print according to the following procedure.
Paper type Weight
1st
drawer
Bypass
feed
ADU
2nd
drawer
(PFU)
PFP
upper
drawer
<20H/23H/
25H, 23HA/
28HA>
PFP lower
drawer
<20H/23H/
25H, 23HA/
28HA>
Plain paper
64 - 80 g/m
2
17 - 20 lb. Bond
4100 (*1) 4103 (*1) 4110 (*1) 4101 (*1) 4108 (*1) 4109 (*1)
Thick paper 1
81 - 105g/m
2
21 - 28 lb. Bond
- 4104 (*1) 4120 (*1) - - -
Thick paper 2
106 - 163g/m
2
29 lb. Bond -
90 lb. Index
- 4105 (*1) - - - -
Thin paper
52 - 63 g/m
2
- 4102 (*2) - - - -
OHP - - 4107 (*3) - - - -
Envelope - - 4405 (*4) - - - -
(*5) 1: Single-sided grid pattern
(Code) [START]
[0][5]
[Power]
Current value
displayed
(Sub Code) [START]
[STRAT]
(Select the paper source)
Enter new
value
[1] (*5)
[OK]
[SETTINGS]
(Test print)
(Stored in memory)