8
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
ERROR CODE AND TROUBLESHOOTING
8 - 9
E714 RADF jam Feed signal reception jam: The feed signal
is received even no original exists on the
original feeding tray.
P. 8 - 4 2 Y Y Y Y
E721 Jam not reaching the read sensor: The
original does not reach the read sensor
after it has passed the registration sensor
(when scanning obverse side) or the
reverse sensor (when scanning reverse
side).
P. 8 - 4 2 Y Y Y Y
E725 Stop jam at the read sensor: The trailing
edge of the original does not pass the read
sensor after its leading edge has reached
this sensor.
P. 8 - 4 3 Y Y Y Y
E726 Stop jam at the exit sensor: The trailing
edge of the original does not pass the exit
sensor after its leading edge has reached
this sensor.
P. 8 - 4 3 Y Y Y Y
EAD0 Other jam Print end command time-out jam: Jam
occurred because print operation did not
finish normally due to communication error
on main board
P. 8 - 4 1 Y Y Y Y
EB50 Paper transport
jam
Paper remaining on the transport path: The
multiple feeding of preceding paper caused
the misfeeding of upcoming paper.
P. 8 - 2 1 Y Y Y Y
EB60 Paper remaining on the transport path: The
multiple feeding of preceding paper caused
the misfeeding of upcoming paper
(redetection after no jam is detected at
[EB50]).
P. 8 - 2 4 Y Y Y Y
Error
code
Classification Contents
Trouble-
shooting
20L/
23L/
25L
20H/
23H/
25H
23LA/
23LM/
28LM
23HA/
28HA
To Next Page
Loading...
