e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
FIRMWARE UPDATING
11 - 14
(7) Click the [Update] button.
The update starts and a status bar appears on the operating panel of the equipment.
Notes:
From 1 to 2 minutes are required to update.
Fig.11-15
(8) The following messages appear if the program data is not transmitted correctly.
Fig.11-16
(9) When the program data transmission is completed, the message shown below appears.
Fig.11-17
(10) Turn OFF the power of the equipment.
(11) If you update the system ROM, initialize the updated data.
• Turn ON the power while [0] button and [8] button are pressed simultaneously.
• Key in “9030”, and then press the [START] button.
• Press the [OK] button.
(12) When the update is finished, remove the USB cable.
FIRMWARE UPDATE
FIRMWARE UPDATE OK
MACHINE POWER OFF/ON
To Next Page
Loading...
