© 2004 - 2007 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO200L/202L/203L/230/232/233/280/282/283
ADJUSTMENT
3 - 45
3
(3) After winding the wires around the pulleys, attach the wire holder jigs not to loosen the wires.
Notes:
• When the wire holder jig is attached, make sure that the wire is not shifted or loosened.
• The wire should come out of the slot of the wire holder jig and be passed through between the
arm and the jig.
Fig. 3-34
Arm
Wire holder jig
To Next Page
Loading...
