e-STUDIO200L/202L/203L/230/232/233/280/282/283 © 2004 - 2007 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND SELF-DIAGNOSTIC MODE
2 - 32
2.2.2 Input check (Test mode 03) (e-STUDIO202L/203L/232/233/282/283)
<Operation procedure>
Note: Note:
Initialization is performed before the equipment enters the test mode.
Fig. 2-3 Example of display during input check
Items to be checked and the condition of the equipment when the buttons [A] to [H] are highlighted are
listed in the following pages.
The status of each input signal can be checked by pressing the [FAX] button, and the digital keys in
the test mode (03).
[0][3]
[POWER]
[START] [FAX] [Digital keys]
[CLEAR]
(LCD ON)
[POWER] OFF/ON
(Exit)
07/11
To Next Page
Loading...
