e-STUDIO200L/202L/203L/230/232/233/280/282/283 © 2004 - 2007 TOSHIBA TEC CORPORATION All rights reserved
ADJUSTMENT
3 - 88
3.12.4 Adjusting the tension of the stack processing motor belt
<Procedure>
(1) Remove the right inner cover and the rear cover.
(2) Remove the 2 mounting screws, and detach
the grip unit.
Fig. 3-118
(3) Loosen the screw on the tension arm plate.
(The tension arm plate will be pulled under
tension by the tension spring.)
Fig. 3-119
(4) Move the returning roller shaft to its lower
limit (the slack of a belt is lightly taken); then,
tighten the screw on the tension arm plate.
Fig. 3-120
Screw
Grip unit
Screw
Screw
Tension arm
plate
Screw
Tension arm
plate
Returning
roller shaft
To Next Page
Loading...
