e-STUDIO200L/202L/203L/230/232/233/280/282/283 © 2004 - 2007 TOSHIBA TEC CORPORATION All rights reserved
ADJUSTMENT
3 - 90
3.12.5 Releasing the stack tray guide lever fixing plate
<Procedure>
(1) Remove the right inner cover and the rear
cover.
(2) Remove the finisher control PC board, PC
board bracket and sensor PC board.
(3) Remove the stack tray.
(4) Remove the stack tray drive unit.
(5) Place the stack tray guide lever fixing plate
so that it is in view through the hole in the
side plate (front, rear). Then remove the fix-
ing screw. (Perform the same for the front
and the rear.)
Note: Note:
When removing the mounting screw, be sure
to hold the stack tray guide lever up from
below.
Fig. 3-122
Fig. 3-123
Screw
Stack tray
guide lever
fixing plate
Stack tray
guide lever
To Next Page
Loading...
