© 2004 - 2007 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO200L/202L/203L/230/232/233/280/282/283
POWER SUPPLY UNIT
7 - 3
7
7.2 Fuse
When the power supply secondary fuse is blown out, confirm that there is no abnormality with each part
using the following table.
Voltage Board/Unit Part Fuse type
+24VD1 LGC Main motor F3:8A (Semi time-lag)
Toner motor
Polygonal motor
Tray-up motor
Internal cooling fan 1
Internal cooling fan 2
Auto-toner sensor
Upper drawer feed clutch
Lower drawer feed clutch
Registration roller clutch
Upper transport clutch
Middle transport clutch
Lower transport clutch
Discharge LED
Main switch
PFP/LCF
+24VD2 LGC Exit motor F5:8A (Semi time-lag)
ADU motor
Exhaust fan
Bypass feed clutch
ADU clutch
Bypass pickup solenoid
High-voltage transformer
Key copy counter / Copy key card
Bridge unit / Job separator / Offset tray
+24VD3 RADF F6:4A (Semi time-lag)
+24VD4 SLG Scan motor F5:8A (Semi time-lag)
Exposure lamp (Lamp inverter)
+24VD5 Finisher F4:5A (Semi time-lag)
06/10
To Next Page
Loading...
Need help?
General
