© 2004 - 2007 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO200L/202L/203L/230/232/233/280/282/283
ERROR CODE AND SELF-DIAGNOSTIC MODE
2 - 3
2
E3C0 Paper transport jam LCF transport jam (Paper not reaching the registra-
tion sensor): The paper does not reach the registra-
tion sensor after it has passed the 1st transport
sensor.
P. 5 - 3
E3D0 LCF transport jam (Paper not reaching the 1st
transport sensor): The paper does not reach the 1st
transport sensor after it has passed the 2nd trans-
port sensor.
P. 5 - 4
E3E0 LCF transport jam (Paper not reaching the 2nd
transport sensor): The paper does not reach the
2nd transport sensor after it has passed the LCF
feed sensor.
P. 5 - 6
E400 Cover open jam Transfer cover open jam: The transfer cover has
opened during printing.
P. 5 - 2 2
E410 Front cover open jam: The front cover has opened
during printing.
P. 5 - 2 3
E420 PFP side cover open jam: The PFP side cover has
opened during printing.
P. 5 - 2 4
E430 ADU open jam: The ADU has opened during print-
ing.
P. 5 - 2 5
E440 Side cover open jam: The side cover has opened
during printing.
P. 5 - 2 5
E450 LCF side cover open jam: The LCF side cover has
opened during printing.
P. 5 - 2 6
E480 Bridge unit open jam: The bridge unit has opened
during printing.
P. 5 - 2 6
E490 Job separator cover open jam: The job separator
cover has opened during printing.
P. 5 - 2 7
E491 Offset tray cover open jam: The offset tray cover
has opened during printing.
P. 5 - 2 7
E510 Paper transport jam
(ADU section)
Stop jam in the ADU: The paper does not reach the
ADU exit sensor after it has passed the ADU
entrance sensor.
P. 5 - 8
E520 Jam not reaching the ADU entrance sensor: The
paper does not reach the ADU entrance sensor
after it is switchbacked in the exit section.
P. 5 - 9
E550 Other paper jam Paper remaining jam on the transport path: The
paper is remaining on the transport path when print-
ing is finished (caused by a multiple paper feeding).
P. 5 - 1 0
Error code Classification Contents Troubleshooting
To Next Page
Loading...
