e-STUDIO200L/202L/203L/230/232/233/280/282/283 © 2004 - 2007 TOSHIBA TEC CORPORATION All rights reserved
ADJUSTMENT
3 - 94
Note: Note:
Perform the shipping position operation when the finisher is packed again.
Lower stack tray
motor (down)
The lower stack tray moves down
and stops when the lower stack tray
lower limit sensor is turned ON.
• Press SW2 again.
• Turn OFF the joint
sensor (S4).
Stapler motor The stapler motor stops after the sta-
pling operation.
• Press the stapler
safety switch (S14).
• Turn OFF the joint
sensor (S4).
Shipping position
operation
The upper and lower stack trays
move to the shipping position and
stop.
• Turn OFF the joint
sensor (S4).
Setting Item Operation To stop
ON
12345678
ON
12345678
ON
12345678
To Next Page
Loading...
