© 2004 - 2007 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO200L/202L/203L/230/232/233/280/282/283
ADJUSTMENT
3 - 103
3
(3) Fix the adjustment screws in the position as shown in the figure.
• Dogleg image A
Install the adjustment screws as shown in the figure below so that the stay of the fuser unit
can move upward.
Fig. 3-142
• Dogleg image B
Install the adjustment screws as shown in the figure below so that the stay of the fuser unit
can move downward.
Fig. 3-143
(4) Check the copied image. If further adjust-
ment is needed, fix the adjustment screws in
the position as shown in the figure so that the
stay can be moved both upward and down-
ward by 1 mm.
Be sure to make the scales on the right and
left match when installing the adjustment
screws.
Fig. 3-144
Installation position of the adjustment screws
Adjustment screws
Dogleg image A:
Adjustment screws
Dogleg image B:
Installation position of the adjustment screws
Scale
06/01
To Next Page
Loading...
