e-STUDIO200L/202L/203L/230/232/233/280/282/283 © 2004 - 2007 TOSHIBA TEC CORPORATION All rights reserved
TROUBLESHOOTING
5 - 36
[ 2 ] Paper jam in puncher unit
[E9F0] Punching jam
MJ-1025
Is there any paper remaining on the transport path in the finisher or equipment?
YES Remove the paper.
NO
Is the connector J1006 on the punch controller PC board disconnected?
Is the harness connecting the punch controller PC board and punch home position sensor
(PI1P) open circuited?
YES Connect the connector securely. Replace the harness.
NO
Is the punch home position sensor working properly?
l
NO 1) Connect the connector of the punch home position sensor securely.
2) Replace the punch home position sensor.
YES
Replace the punch controller PC board.
To Next Page
Loading...
