e-STUDIO200L/202L/203L/230/232/233/280/282/283 © 2004 - 2007 TOSHIBA TEC CORPORATION All rights reserved
FIRMWARE UPDATING
6 - 28
<Updating Finisher ROM>
(1) Install the ROM to the download jig.
Make sure the direction is correct (P.6-4 "Fig. 6-3").
(2) Turn OFF the power of the equipment.
(3) Take off the finisher rear cover.
Fig. 6-29
* Connect the finisher interface cable with the equipment after removing the finisher rear cover.
(4) Connect the download jig with the jig connector on the finisher control PC board.
Fig. 6-30
Finisher rear cover
Connector
To Next Page
Loading...
