Toshiba e-Studio2505 - Preparation; Components; Front;Right;Inner Side

1 PREPARATION
8 Components
Components
 Front/Right/Inner side
1. Automatic Document Feeder (ADF) (optional)
Load up to 50 originals (80 g/m
2
or 20 lb. Bond) to scan one sheet after another. (The maximum number you can load
may vary depending on the type of original.)
 P.93 “Paper Misfeed”
The Automatic Document Feeder is only available for Europe.
2. Platen cover
Close this before start copying or scanning.
3. Side cover
4. Bypass tray
Place special paper such as thick paper, overhead transparencies, or tracing paper.
 P.19 “Loading paper on the bypass tray”
 P.21 “Loading an envelope on the bypass tray”
5. Drawer
Place up to 250 sheets of plain paper (80 g/m
2
or 20 lb. Bond).
 P.17 “Loading paper in the drawer”
6. Front cover
Open this when you replace the toner cartridge.
 P.98 “Replacing Toner Cartridge”
7. Toner cartridge
For the recommended toner cartridges, refer to the Safety Information.
 P.98 “Replacing Toner Cartridge”
2
3
4
5
7
6
1