1 PREPARATION
10 Components
5. AC-IN terminal (rear)
Connect the power cable supplied with the equipment.
6. USB terminal (4-pin)
Connect to your PC using a commercially available USB cable.
y Use a USB2.0 Hi-Speed certified cable: USB cable supporting the USB2.0 Hi-Speed mode (480 Mbps of
transfer speed) certified by the USB Implementers Forum.
y Connect the equipment with a PC directly by the USB cable. When it is connected with a PC via a USB hub, the
equipment may not be recognized.
7. Receiving tray
8. Scanning area
The data of originals transported from ADF are scanned here.
P.104 “Regular Cleaning”
The scanning area is only available for Europe.
9. Original scale
Confirm the size of an original placed on the original glass.
10. Platen sheet
P.104 “Regular Cleaning”
Configuration of options
The available options are listed below. Contact your service technician or service representative for details.
Control panel
The functions and indications of the button vary depending on the region. The illustrations show the control panel for
Europe and the Americas unless they are specified.
Main body
Automatic Document Feeder
(
MR-2021
)
* Only for Europe
To Next Page
Loading...
