3 INSTALLING PRINTER DRIVERS FOR WINDOWS
66 Installing the Printer Drivers
9
Confirm that the installation is completed, and then click [Finish].
The Installer may ask you to restart your computer. If it does, select “Yes, I want to restart my
computer now.” and click [Finish] to restart your computer.
Before using the printer driver for printing, configure the installed options of the equipment and
department code (if required) on the printer driver. Refer to the Printing Guide for the
instructions.
If your TOSHIBA MFP is not found
If your TOSHIBA MFP is not found, you must first install the printer driver by temporarily selecting a local port
and then configuring the Raw TCP/LPR port.
If this equipment is not discovered over the network after the installation is started, a dialog box indicating
this appears. Click [Continue] to continue the configuration.
7
Select [Use the following port] and then select “LPT1: ”. Then click [OK].
The Ready to Install the Program screen is displayed.
To Next Page
Loading...
Need help?
General
