9
© 2004 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO200L/202L/203L/230/232/233/280/282/283
PAPER FEEDING SYSTEM
9 - 1
9. PAPER FEEDING SYSTEM
9.1 Functions
The purpose of this system is to pick up a sheet of paper from the drawer or bypass tray and transport
it to the transfer position. The paper feeding system mainly consists of the pickup roller, feed roller, sep-
aration roller, transport roller, registration roller, bypass paper sensor, drawer empty sensor, drawer
paper stock sensor, feed sensor, registration sensor and the drive system for these components.
This manual explains the paper feeding system assuming that the lower drawer (drawer module) is
installed although it is available as only an option (MY-1021) depending on the destination or version.
Sectional view of paper feeding section (Front side)
Fig. 9-1
No. Name No. Name
1 Upper drawer separation roller 13 Bypass separation roller
2 Upper drawer feed roller 14 Upper drawer tray-up sensor
3 Upper drawer pickup roller 15 Upper drawer empty sensor
4 Lower drawer separation roller 16 Upper drawer paper stock sensor
5 Lower drawer feed roller 17 Lower drawer tray-up sensor
6 Lower drawer pickup roller 18 Lower drawer empty sensor
7 Registration roller (rubber) 19 Lower drawer paper stock sensor
8 Registration roller (metal) 20 Registration sensor
9 1st transport roller 21 1st transport sensor
10 2nd transport roller 22 2nd transport sensor
11 Bypass pickup roller 23 Bypass paper sensor
12 Bypass feed roller
1
12
6
17
8
9
11
15,16
3
20
14
5
13
2
23
10
7
4
22
18,19
21
04/09
To Next Page
Loading...
