e-STUDIO2020C/2330C/2820C/2830C/3520C/3530C/4520C © 2008 - 2011 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
6 - 48
[EAC0] Transport delay jam
MJ-1030
1. Check if there is any paper in the finisher, saddle stitcher or the on the transport path of the
equipment. Remove it if there is.
2. Is the connector J708 on finisher controller PC board disconnected?
3. Is the harness between the finisher controller PC board and inlet sensor [PI33] open circuited?
4. Is the inlet sensor working properly? (Check the movement of the actuator.)
5. Replace the sensor.
6. Replace the finisher controller PC board.
To Next Page
Loading...
Need help?
General
