e-STUDIO2020C/2330C/2820C/2830C/3520C/3530C/4520C © 2008 - 2011 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
6 - 80
[CC31] Transport motor abnormality
[CC40] Swing motor abnormality
[CC41] Paper holder cam home position abnormality
* You receive a [CC31] error when the [ED12] error occurs three times in succession.
MJ-1101
Is there any mechanical problem when the stack transport roller -1 and -2 are rotated?
YES Fix the mechanism.
NO
Is the harness between the transport motor (M2) and the finisher control PC board (CN5)
disconnected or open circuited?
l
YES • Reconnect the connector securely.
• Replace the harness.
NO
1. Replace the transport motor (M2).
2. Replace the finisher control PC board.
MJ-1030
Is the swing unit home position sensor (PI35) normal?
NO Replace the sensor.
YES
Is the wiring between the finisher controller PC board and the swing motor (M36) correct?
NO Correct the wiring.
YES
Is the swing mechanism normal?
NO Fix the mechanism.
YES
1. Replace the swing motor.
2. Replace the finisher controller PC board.
MJ-1101
Is there any mechanical problem when the paper holder cam is rotated?
YES Fix the mechanism.
NO
Is the harness between the paper holder home position sensor (S6) and the finisher control PC
board (CN17) disconnected or open circuited?
l
YES • Reconnect the connector securely.
• Replace the harness.
NO
1. Replace the paper holder home position sensor (S6).
2. Replace the finisher control PC board.
To Next Page
Loading...
