Toshiba e-STUDIO347CS - Creating Bookbinding Margin

EDITING FUNCTIONS
- 99 -
2
1
3
4
5
6
7
4
Select the type of binding margin.
5
Adjust the width of the binding margin.
1) Press [FRONT MARGIN] and adjust the binding
margin width on the front side using [ 0 mm]
(0") and [ 100 mm] (3.94"). (The width on the
back side will be also adjusted in the same way.)
2) Press [BACK MARGIN] and adjust the binding
margin width on the back side using [ 0 mm]
(0") and [ 100 mm] (3.94"). (Only the width on
the back side will be adjusted.)
3) Press [OK].
Memo
• Note that a left/right binding margin will be created on
the opposite side on the back side of paper in duplex
copying. (For example, when a binding margin is
created on the right of the front side of the paper, it will
be created on the left of the back side.)
6
Press [OK].
7
Select other copy modes as required, and
then press the [START] button on the
control panel.
Creating bookbinding margin
You can easily make a binding margin when you copy a book-
type original on both sides of the paper.
 Basic Guide
1
Press [IMAGE SHIFT] on the EDIT menu.
2
Press [BOOK].
3
Adjust the width of the binding margin.
1) Press either [ 0 mm] (0") or [ 30 mm] (1.18").
2) Press [OK].