2.PRINTING FROM WINDOWS APPLICATIONS
Setting the Layout and Finishing Options 33
PRINTING FROM WINDOWS APPLICATIONS
6
Set the margins in [Margin].
[Center]: This sets the gutter in the center of a two-sided page. You can enter up to 16.90 mm (0.67 inches).
Printed images are reduced according to the margin setting.
[Outer]: This sets the gutter on the right and left of the paper. You can enter up to 29.60 mm (1.17 inches). Printed
images are reduced according to the margin setting.
[Units]: This sets the unit of measurement used for the margins.
If you select [Booklet without Center Margin], the value in [Center] becomes invalid and the center margin
becomes 0 mm (inches).
7
Select [Folding] to fold the document at its center.
[Folding] is only available when the Saddle Stitch Finisher is installed.
8
Select [Staple Down the Center], to double-staple the center.
[Staple Down the Center] is available only when the Saddle Stitch Finisher is installed and configured on the
[Device Settings] tab.
9
Click [OK].
10
Set other printing functions as needed, and then click [OK].
11
Click [Print] or [OK] to send the job.
If the Saddle Stitch Finisher is installed, the printed document is folded when [Folding] is selected. If this is not
installed, fold the printed document manually.
To Next Page
Loading...
