e-STUDIO350/352/353/450/452/453 © 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND SELF-DIAGNOSTIC MODE
2 - 4
E724 RADF jam Stop jam at the registration sensor: The trailing
edge of the original does not pass the registration
sensor after its leading edge has reached this sen-
sor.
P. 5 - 2 8
E725 Stop jam at the read sensor: The trailing edge of the
original does not pass the read sensor after its lead-
ing edge has reached this sensor.
P. 5 - 2 8
E726 Transport/exit signal reception jam: RADF receives
the transport/exit reception signal from the equip-
ment when no original is at the exposure waiting
position.
P. 5 - 2 8
E731 Stop jam at the exit sensor: The trailing edge of the
original does not pass the exit sensor after its lead-
ing edge has reached this sensor.
P. 5 - 2 9
E741 Stop jam at the reverse sensor: The trailing edge of
the original does not pass the reversal sensor after
its leading edge has reached this sensor.
P. 5 - 2 9
E742 Jam not reaching the reverse sensor (during
reverse feeding): The leading edge of the original
does not reach the reverse sensor when original is
fed from the reverse section.
P. 5 - 3 0
E743 Jam not reaching the exit sensor (during reverse
feeding): The original does not reach the exit sen-
sor after it has passed the reverse sensor when the
original is exited from the reverse section.
P. 5 - 3 0
E860 Jam access cover open: The jam access cover has
opened during RADF operation.
P. 5 - 3 0
E870 RADF open jam: RADF has opened during RADF
operation.
P. 5 - 3 1
E910 Finisher jam (Bridge
unit)
Jam at the bridge unit transport sensor-1: The
paper does not reach the bridge unit transport sen-
sor-1 after it has passed the exit sensor.
P. 5 - 3 2
E920 Stop jam at the bridge unit transport sensor-1: The
trailing edge of the paper does not pass the bridge
unit transport sensor-1 after its leading edge has
reached the sensor.
P. 5 - 3 2
E930 Jam at the bridge unit transport sensor-2: The trail-
ing edge of the paper does not reach the bridge unit
transport sensor-2 after its leading edge has
reached the bridge unit transport sensor-1.
P. 5 - 3 2
E940 Stop jam at the bridge unit transport sensor-2: The
trailing edge of the paper does not reach the bridge
unit transport sensor-2 after its leading edge has
reached the bridge unit transport sensor-2.
P. 5 - 3 2
E950 Job separator jam Jam not reaching the job separator transport
switch: The paper has passed through the exit sen-
sor does not reach the job separator transport
switch.
P. 5 - 1 0
E951 Stop jam at the job separator transport switch: The
trailing edge of the paper does not pass the job sep-
arator transport switch.
P. 5 - 1 0
E960 Offset tray jam Jam not reaching the offset tray transport switch:
The paper has passed through the exit sensor does
not reach the offset tray transport switch.
P. 5 - 1 0
E961 Stop jam at the offset tray transport switch: The
trailing edge of the paper does not pass the offset
tray transport switch.
P. 5 - 1 0
Error code Classification Contents Troubleshooting
06/01
To Next Page
Loading...
