e-STUDIO350/352/353/450/452/453 © 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
ADJUSTMENT
3 - 10
(5) If not, use the following procedure to change values and measure the distance E again.
<Procedure>
(Adjustment Mode) → (Key in the code [498]) → [START] → [1] → [START]
→ (Key in a value (acceptable values: 0 to 255) )
→ [ENTER] or [INTERRUPT] (Stored in memory).
→ "100% A" is displayed
→ Press [3] → [FAX] → (A grid pattern is printed out.)
* The larger the adjustment value is, the longer the distance E becomes. (approx. 0.05 mm/
step)
Fig. 3-2 Grid pattern
A
21
6
1
B, E
D
6
30 2
C
10
Feeding direction
[Grid pattern]
04/09
To Next Page
Loading...
