e-STUDIO350/352/353/450/452/453 © 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
ADJUSTMENT
3 - 30
[ 1-1 ] Installation of the current measuring jig
Notes:
• Clean the toner recovery auger when the toner is sticking to it. Then attach the jig.
• Do not damage the tip of the separation fingers.
(1) Open the front cover.
Fig. 3-13
(2) Remove the toner bag.
Fig. 3-14
(3) Pull up the hinge pin and extract it.
(4) Take off the front cover.
Fig. 3-15
Front cover
Toner bag
Front cover
Hinge pin
To Next Page
Loading...
