e-STUDIO350/352/353/450/452/453 © 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
ADJUSTMENT
3 - 74
[B] Adjustment
(1) Close the RADF.
(2) Adjust it by turning the adjustment screws on the hinges.
• Adjust the height on the rear side by means of the screw on the hinge on the feed side of the
RADF.
Turn it clockwise ................. Heightened
Turn it counterclockwise ...... Lowered
Fig. 3-98
• Adjust the gap on the rear side by means of the screw on the hinge on the feed side of the
RADF.
Turn it clockwis .................... Lowered
Turn it counterclockwise ...... Heightened
Fig. 3-99
05/11
To Next Page
Loading...
